How to Install Underwater Boat Lights?
We know that boat is a craft that floats or works on the water. It is used to travel a long distance through water. Many people think that it is used only for conveyance, but it has many other uses.
One of the major roles of the boat is to catch large fishes. These large fishes can be used as food, and they can also be used as a source of money.
These large fishes are predators and live on bait (small) fishes. Bait fishes are easily attracted by using a boat with underwater lights. Read this: AfterPaints for more information.
Now we will tell you "how to install underwater boat lights?" to make your boat more attractive for bait fishes.
How can you install underwater boat lights?
While underwater lights of the boat are not used for protection purposes, it just gives a good look to your boats and traps large predator fishes.
Installation of underwater boat lights depend on:
• The type of boat
• The look of the boat
• What sketch you have in your mind.
• The procedure to be applied
• The color of emitting light
Here the selection of light is a point of concern.
Choosing Underwater lights:
There are two main options for underwater lights that are LED and tungsten. Many professionals prefer LED over tungsten because LED has more advantages than tungsten. LED lights have a long life, do not heat up easily, and require less power supply.
Now we present the process of installation of underwater boat lights.
Process of installation:
Some people think that it is a very simple task to install underwater lights. They drill a hole in the boat and fit underwater lights there. It spoils the structure of the boat and causes water to enter the boat through the hole.
The best way is fitting up lights in a cored hull. If you have a boat having a cored hull, then follow these steps to install underwater lights.
Step 1: Go inside the boat to check the hull carefully.
Make sure that there is no structural irregularity or any other problem in the hull. Anything that causes problems will eventually affect the placement of light in the hull.
Step 2: Measure and mark the central position of light on the outer side using a pencil. After the measurement, drill the hull through the marks. Separate drill bit and chuck. Keep drill bit in the hole so that you can see the inside of the boat easily.
Step 3: Apply pressure on the drill at a slow speed. There is much variation in the size of the lights.
The hole made through drill is different for different lights.
Step 4: Wipe the hole from the inner side to remove dirt and grease. Seal the edges by brushing with epoxy resin. Dry the epoxy resin. Fit the cables and light properly in the hole.
Step 5: On the inner side, screw the nut and connect wires to a suitable switch. Check all the connections before you turn on the light.
Final thought:
Many professionals apply high charges to install underwater boat lights. You can install these lights in your boat with proper guidance and knowledge. In this way, you can save money and time as well.
